Operating Scrap Dragon > Main Menu > Back Office > Maintenance > Setup > Local Computer Options > Peripherals > ID Data Capture Configuration > OCR Scanner |
DO NOT plug in OCR scanner until instructed to do so in these instructions.
Setting up the OCR Scanner
Step 1: Run the SDK_setup.exe located in the dragon folder on your server. The following is the path where the file is located. \\your_server_name\dragon\setup\drivers\scanshell\SDK_setup.exe. Select the ScanShell 800 when proceeding through the installation. Proceed through the installation using all of the defaults. After completing the installation, move to step 2.
Step 2: Log in to Scrap Dragon. Goto Back Office>Maintenance>Setup>Local Computer Options> Peripherals. Select the OCR Scanner and hit save. Exit out of Scrap Dragon. After logging completely out of Scrap Dragon, move to step 3.
Step 3: Plug OCR scanner into an available USB port. Follow all of the Windows defaults as it attempts to install. After Windows has finished doing its install, move to step 4.
Step 4: Log back in to Scrap Dragon. Goto Back Office>Maintenance>Setup>Local Computer Options> Peripherals. Retrieve the calibration paper that came with the OCR scanner. Insert one of the papers with black stripes down, and arrows to the top, in the OCR scanner and hit calibrate. The system will ask you to insert the calibration paper. Select OK. At this point, the OCR scanner should begin to take the calibration paper very slowly. Once the paper has fed all the way out of the OCR scanner, move to step 5.
Step 5: Select your state and select Auto-detect state. After these selections, hit save and exit out of this menu. The OCR scanner is ready to be used.